Wednesday, 13 June 2012

Basic Semiconductor Theory


In years before the Second World War solid state electronic devices were unknown. Vacuum tubes, magnetic amplifiers and relays were the only devices which were used in the processes of electrical signal generation, amplification, transmission, wave shaping and switching. After the invention of the transistor in - 1944 and subsequent development and improvement of the transistor and other solid state electronic devices, vacuum tubes are being replaced in many fields of applications, except in high-power
applications, by these solid state devices A solid state electronic
device consists of a semiconducting material and the development of a wide variety of semiconductor devices is due to wide range of electrical properties which a semiconductor acquires by minor chemical additions of some elements.
In this chapter we give a brief account of simple atomic theory of semiconductors.
11. Semiconductors.
The electrical resistivity of a good conductor like copper or
silver is very small, while that of an insulator is very large. F'or
example, the resistivity of silver is 1.6 x10-8 ohm-m and that of quartz is about 1012 ohm-rrt. - A semiconductor is a solid material whose electrical resistivity is higher than that of a conductor and lower than that of an insulator. Typical values of the resistivity of a semiconductor lie between 10-2 and 1 ohm m at room temperatures. This is not the only essential characteristic of a semiconductor. Other essential characteristics of a semiconductor are : -
(i) The electrical resistance of a semiconductor decreases with increase in temperature over a particular temperature-range which is charaCteristic of the semiconductor.

Per Amplifiers


The function of voltage amplifiers discussed in chapter 7 is to increase a signal voltage from a low level to a higher level which is required for operating some low-power circuit. Such amplifiers are generally operated under class A conditions so that the amplification is without distortion. The final stage of multi-stage amplifier is usually required to drive a loudspeaker or some load which requires sufficient power for its operation. Thus such a stage must supply large and undistorted power to the load. The final stage which does this function is called a large signal or a power amplifier.
A power amplifier is defined as a frequency converter which changes d.c. power into a.c. signal power. The input power is supplied by the d.c. source and the average power in the circuii is distributed according to the relation
d.c. power input=a.c power output-f losses.
A bipolar junction transistor that is suitable for a power amplifier is called a power transistor. It differs from other transistor in the following respects :
(i) The area of the collector region of a power transistor is large and the collector is attached firmly to a metallic heat sink so that heat, which is generated mainly in the depletion region between the collector and the base is taken away quickly.
(ii) In a power transistor the emitter and base layers are heavily doped and the contact area between the base layers and the base leads is in ring like form so that the area is increased. Consequently the ohmic resistance between the emitter and the base is very low. Because of this low resistance, a power transistor requires low input power, the saturation voltage in the output circuit becomes smaller and the current gain becomes more uniform.
Power amplifiers may be operated as class .4, class B, class AB, or class C. In this chapter we NN ill describe two classes of power amplifiers which are common in transistor circuits. They are class A, and class B push-pull power amplifiers.
In class A power amplifier the load is not directly connected in the collector circuit because of the following reasons. The quiescent current through the load resistance gives rise to a large wastage of power. If the load is the voice coil of a loudspeaker, a large d.c. quiescent current through the voice coil would cause damage to it. Hence in class A power amplifier the load is always coupled to the collector circuit by means of a transformer. Therefore, we will discuss class A power amplifier with transformer coupling only.
92. Transformer-Coupled class A Power Amplifier.
Dynamic speakers used in audio-amplifiers and in radio receivers are low impedance devices ; the voice coil of a loudspeaker is of the order of 10 ohms. The collector circuit of a power transistor has high impedance. Therefore, to transfer audio power from the collector circuit of the transistor to the speaker a voltage-step down and current-step up transformer is used.
The primary and secondary coils of the transformer are wound on an iron core and it is called an output transformer. The high impedance primary of the output transformer is connected in the high-impedance collector circuit and the low-impedance secondary is connected across the voice coil of the speaker. If RL is the impedance of the speaker, then according to the theory of an ideal transformer, the a.c. load impedance in the collector circuit will be
R' = 1, n2
Rr
number of turns of the.secondary N2
where number of turns of the primary N,
For a step-down transformer a is less than I.
The ratio is called the turns ratio of the
transformer. (The derivation of Eq. (I) is given at the end of this
section) Fig. 9.1 shows the circuit diagram of transformer coupled
class A power amplifier. The resistors R, and R2 provide potential
divider arrangement for forward biasing of the emitter-base

Tuesday, 5 June 2012

Percentages of radio and television audiences


The given lines present the percentages of radio and television audiences over four years old in the UK from October to December 1992. Here, time of day or night is presented horizontally and percentages of population vertically. As is observed, radio and television audiences showed almost the opposite trend having showed a great variation in different times of day or night.
The bold graph here presents television audiences throughout the day. It shows that the percentage was zero in the early morning. But it gradually increased up to ten percent at 8.00 A. M. and remained almost the same with fluctuations up to 4. Then, the line went up very fast and attained its peak point, which was about fifty percent at around eight P. M. After that, the graph fell down pointedly and at four PM the percentage was below five percent, which was the lowest point. Then again a slow upward trend was observed.
On the other hand, the thinner graph describes the percentages of radio audiences. Unlike television, it started from just under ten percent and at eight A. M. attained the peak percentage amounting about 30%. After that, it gradually fell up to 4 P. M. intersecting the bold graph at around one P. M. However, a slight upward trend in the percentages was observed from four to six P. M.
As is observed, Television was much more popular than radio having the highest number of audiences summing almost 50 percent. The percentage is almost twice as much as Radio has. However, both the radio and Television had equal number of audiences at around 12 A. M. at which the two lines intersect each other.
In conclusion, it is clear from the lines that radio was very popular among the audiences in the early morning, on the other hand television got its highest percentage of onlookers in the evening.

Visit Cox's Bazaar sea beach


The supplied line graph provides information related to foreign tourists coming to visit Cox's Bazaar sea beach in Bangladesh throughout the year. As is presented, the number of tourists gradually increases up to July and then there is a downward trend with fluctuations.
According to the graph, initially in the month of January, the number of tourists is well under 2 thousand. But from this, month, there is an upward trend in the number and it reaches a peak in July amounting well above 10 thousand. Then from July to September, the number of tourists fluctuates and after September there observes a downward trend in their number with a slight rise in the month of October.
Finally, it can be concluded that increased number of tourists visit Cox's Bazaar sea beach, the largest beach in the world, in the middle of the year. But the number of visitors at the beginning and end is very poor.

student enrollment of Headway Institute


The given line-graph provides information on student enrollment of Headway Institute for a period of four months in 2003. Here, the horizontal axis shows time and the number of students measured by unit equal to 100 students each is given in the vertical axis. According to the line, enrollment increased for the first three month and then there was a moderate fall in the last month.
As is observed from the graph, initially in the month of January, around 10 units of students enrolled in Headway Institute. Then a gradual increase in enrollment took it to well over 20 units in next month. After that, enrollment peaked at around 90 units with sharp growth in March. But in the next month, there was a deliberate fall in student enrollment amounting just under 60 units.
In conclusion, the number of students enrolled in Headway Institute was quite unpredictable with quick ups and downs.

Saturday, 2 June 2012

Importance of Resolution and Density


The Importance of Resolution and Density for Scanning Microfilm
Normal microfilm is a high contrast recording medium that was never designed to capture halftone or continuous tone material, photographs, negatives, prints, and heavily illustrated print material. But, it is possible to link the capabilities of the Hermann & Kraemer (H&K) high resolution 35mm planetary camera that is capable of resolving more than 200 lines per millimeter to a Continuous Tone Filming (CTF) process that successfully captures continuous tom images with great fidelity and adheres to all preservation standards. Continuous tone filming is not new, but previous techniques used either non-preservation film bases (acetate) or suffered from loss of resolution both during original image capture and during duplication. The CTF process suffers from neither of these limitations. Resolution occasionally exceeding 200 lines per millimeter is achieved using this technique. While there is some loss of resolution during duplication, it is often not measurable; that is the resolution measured from the standard test target remains the same. One measure of quality is that third generation CTF images have been taken to a reputable photo shop and high quality paper prints produced.
The second factor for successful scanning of microfilm to a digital image is density variation. Preservation standards allow density to range .20 density points within a roll of microfilm. However, the narrower the range of densities on a roll of microfilm, the more readily it can be scanned without making adjustments for changes in density throughout the roll of microfilm being scanned. There is at least one system that is specifically designed to produce preservation microfilm with narrow density ranges, ExpoSureTm developed by MAPS The MicrogrAphic Preservation Service, Inc. A US patent was awarded for ExpoSureTm in 1992. ExpoSuren" when combined with the resolution capability of the H&K 35mm planetary camera can produce microfilm images with a resolution of 200 lines per millimeter and a density range for a given roll of microfilm that is often less than .05 density points.
These two characteristics, high resolution and narrow density ranges, produce microfilm that is far more easily scanned into a variety of digital formats. Anecdotal evidence suggests that microfilm with narrow density ranges and high resolution can be scanned with significantly fewer adjustments during the course of the scanning process, and the resultant digital image is superior to the use of conventional microfilm techniques.

little French bulldog

My little French bulldog Bumble was on Purina Lamb & Rice when I first got her. We had no problems with her as far as her not liking the food The problem we did have is that she would eat her own waste! We switched her to Hill's Science Diet Lamb Meal & Rice because we thought may be she was lacking something from the Purina food. We are happy to say that since Bumble made the switch to Hill's Science Diet. she has a beautiful shiny coat Plus, we no longer have that 'other' problem. We feed all five of our dogs Hill's Science Diet now. All of them are healthy and happy.